1-Prep your beard, either by taking a warm bathe, or by holding a hot towel against your face. In case you opt for the warm towel; soak a small wipe in warm water and grip it firmly against your face until it’s cool. For finest results, apply the hot towel twice.
2-After prepping your beard run the faucet for the hottest water possible. Fill your mug or bowl with the water, and let your brush soak.
3-Soaked your face and utilize the brush to apply the cleaning soap or shaving cream to the hairy area, swirling until the lather has produced stiff peaks.
4- Spread over the lather to your face utilizing a paintbrush motion using the badger shaving brush. Use a hot towel to wipe away any additional foam, removing oil from the skin follicles so that moisture can go through. A badger Brushs is named for the animal hair used to make the brush.
5- Finish lathering through the use of painting strokes to coat your face with a thick layer.
6-Sharpen the straight razor if necessary, either utilizing a barber hone or the side of the strop that’s been treated with abrasive paste.
7-strop the straight razor 15 round trips on the linen ( linen), followed by sixty encircling trips on the strop, permits the foam time to weaken the hair. Facial hair is tough, thick hair, the more time it stays wet, the better it is to shave off.
8- Re-foam your face if the soap has dried out while you had been honing and stropping.
9-Stretch your skin as you shave. Pull the area to which you will apply the razor till it’s stretched.
10-Use a 20 degree angle of the straight razor blade to your dermis. Remember you are not cutting skin, this isn’t your purpose, you are cutting hair as close to your skin as you can.
11- You may make 3 passes for optimal softness. If you wish to save time and are prepared to sacrifice smoothness, you can do a single shift shave and skip the last 2 passes. On each move, you’ll start with quick strokes and end off with longer strokes.
12-Make the primary pass with the grain (which means in the path of hair growth
13- foam up again and make the subsequent move sideways to the grain. You probably will not have the ability to shave your neck on this move, simply the perimeters of your face and jawline.
14-In case you have a very heavy beard, you may wish to strop the straight razor before the third lapse. If your beard is just not that hard, you may skip this step.
15-Make a 3rd and last pass against the grain. This pass is the most harmful and when probably the most damages come about. Remember when trimming side burns that the tip is close to your earlobe, and be very careful when shaving the clumsy shapes around your neckline. Some males desire to make use of water only, with no foam, for the third move, to better see what they are doing. When you have a heavy beard, chances are you’ll find this irritates your pores and skin too much. In such a case, go forward and use the foam.
16- Wash the foam off your face with cold water. Cold water will assist block the pores in your skin.
17-Dry the razor. Run a sq. of bathroom paper between the scales of the handle to take away the droplets of humidity which might be trapped there. Most old straight razors are high carbon steel and will corrode).
18-Wash the shaving brush shake out the excess humidity, and hold it upside-down in a brush holder to dried up.
Before you go anywhere, visit Straight Razor and Shaving Razor
categories: health,beauty,skin care,women,acne,cosmetics,tools,razor,men